The G8JCFSDR is an SDR which uses RF front-end hardware to down-convert RF frequencies into the 0~24KHz range accepted by most PC soundcards. The PC reads in the soundcard signal and carries out all of the filtering, demodulation, AGC, and notch filtering in software rather than hardware as would be the case in a traditional receiver. Because the receiver is all software, there are things you can do which would be almost impossible in h/w. This is Peter Carnegie's (G8JCF) SDR software. Contact G8JCF The G8JCFSDR works with very many SDR H/W front-ends, eg FiFiSDR, Pappradio V1 & V2, PMSDR, Elektor SDR, DRT1, DRB30, DRB32, Soft66AD(M), Lazy Dog LD1, EXTIO_*.DLL supported H/W Special support has been built in for Burkhard Kainka's ELEKTOR 3/2004, 5/2007, 7/2016, Ulf Schneider's DRT1, and the NTI DRB30/32, & the PappradioV1 hardware down-converters. The G8JCFSDR will also work with home-brew IQ and NON-IQ Receivers using AD9835/AD9850/AD9851/AD9951 DDS Chips, and with CY27EE16 PLL generators. Full USB support using FTDI US232C RS232/USB converters is supported with full high-speed Bit-Bang mode. If you come across a DRT1 secondhand, snap it up !! The DRT1is a very high performance 0~30MHz to 45MHz IF to 12KHz final IF down-converter. The NTI DRB30/32 are very similar in performance and come in a nice enclosure, again if you come across a secondhand unit, snap it up !! Yahoo has shut down its Yahoo GROUPS service for all practical purposes, so we have migrated to G8JCFSDR group over at GROUPS.IO. I hope that G8JCFSDR users will sign up to the G8JCFSDR@Groups.io please. |
antiX — это быстрый, легкий и простой в установке дистрибутив Linux Live CD без systemd на основе Debian Stable для совместимых с Intel-AMD x86 систем. antiX предлагает пользователям «AntiX Magic» в среде, подходящей для старых и новых компьютеров. Так что не выбрасывайте пока старый компьютер! |
Портал сообщества операционной системы Линукс Минт. веб-сайт предоставляет базу данных программного обеспечения. |